To prevent the unit from tipping forward and provide a stable installation, the unit must be secured in place with an anti-tip blocking kit. In addition, be aware of local codes and ordinances when installing your service.
You must follow all National Electrical Code regulations. Locate electrical within the shaded area shown in the installation illustration. It is recommended that a separate circuit, serving only this appliance, be provided.Īll Built-In models are equipped with a 6' (1.8 m) power supply cord with a 3-prong grounding plug which must be plugged into a mating 3-prong grounding type wall receptacle. The supply circuit for this appliance must be protected by a 15 amp fuse or circuit breaker.
The glass portion of the door must be exposed and not covered by any part of the panel.Ī 115 volt, 60 Hz, 15 amp electrical supply is required. Refer to the panel specifications for exact dimensions. The refrigerator door panel must include a cut-out to accommodate the window. Refer to pages 6–10 for detailed information on adding panels. The overlay design also allows you to add your own handles, or you may choose accessory handles available through your Sub-Zero dealer. If your client has chosen the framed or overlay design, you will be adding front panels to give the unit the custom Sub-Zero look. You will not have to install front panels. If your client has chosen the stainless steel design, the unit will be shipped complete with wrapped stainless steel doors and handle hardware. Refer to the full-scale illustrations at the end of this section for specifics on door openings and filler size alternatives. In any side- by-side installation without a filler strip, add an additional 1/ 2" (13) to your combined numbers. This kit is available through your Sub-Zero dealer.īe sure to add the filler strip width to your finished rough opening dimension. An anchoring kit may also be used to attach two units together.
The width of this filler strip will vary depending on the configuration and panels you use. When units are installed side by side, a filler strip is recommended. A 90˚ door stop is available as an accessory. If you're using raised panels, consider using a wider filler. Refer to the minimum door swing clearance in the specifications chart.įor corner installations, allow for a minimum 3" (76) filler so that the door can open to 90˚. With the door opening at 90˚, you may have to move drawers slightly to clear the door interior. Refer to the illustrations and specifications for overall dimensions, finished rough opening dimensions and installation specifics.Īllow the door to open a minimum of 90˚ or you'll have problems removing drawers.
0 kommentar(er)
